How To Remove Coins Stuck In The Dryer | Dryer Repair Help (2024)

How to Remove Coins Under the Baffles on Whirlpool and Kenmore Dryers

NOTICE: Before doing anything to your dryer, make sure to disconnect it from all power sources.

Coins that make it through the wash cycle often slide under the baffles inside the dryer. When this happens the dryer makes a clanging noise as the drum rotates. The baffles or paddles are use to tumble the clothes while the drum is turning.

1. Lift up the lint filter cover on the top and remove the 2 screws.

2.Facing the front of the dryer, use a very small flat blade screwdriver or spatula and place it between the tub and front panel. Push the spring-loaded clips to the rear and lift the top up and lean it against the wall. The clips are located to the far left and right in the narrow opening between the top and front panel.

3. Open the dryer door and use the baffles to turn the drum clockwise until the baffle screws are on the top. DO NOT TURN THE DRUM COUNTER CLOCKWISE.

- Doing so could cause the belt to come off the motor and idler pulley!

- Remove the screws and lower the baffle to extract the coins and other debris.

- When replacing the screws do not over tighten them.

For more information about how to remove coins stuck in the dryer, read this blog post.

Learn how to remove coins stuck in the washing machine with this blog post.

Find Parts to Repair Your Dryer

We covered how to remove coins stuck in a dryer. If you find that you need a replacement part, feel free to browse our website or visit the dryer parts page.

If you have a hard time finding the part you need for your dryer, just give us a call at 866-236-3848 and one of our Part Experts would be happy to help you find the exact OEM replacement part you are looking for to fix your dryer.

Locating the Model Number on your Dryer

When calling to find an exact replacement part for your dryer, you will need the Model Number ready to go. The model number on a dryer can typically be found in one of four places:

For electric dryers, the model number can be found in the upper back corner, the front side of the cabinet, or the cabinet frame inside the door.

For gas dryers, the model number can typically be found behind the front access panel.

How To Remove Coins Stuck In The Dryer | Dryer Repair Help (2024)

FAQs

How do you get into a dryer drum? ›

Disconnect the light assembly wires and remove the front bulkhead mounting screws so you can detach the bulkhead. This is the flat part in front of the drum. Unhook the belt from the pulley and the motor shaft. These parts are under the drum, and once the belt is fully detached you can lift the drum free.

Why does my dryer sound like it has metal in it? ›

Dryer Is Making a Grinding Noise

Nothing is more alarming than the sound of metal grinding against metal—especially when there is an appliance running. If your dryer is making a grinding noise, the culprit is usually the drum bearing. The drum bearing is in the back of the appliance behind the dryer drum.

Can something get stuck in the dryer? ›

If you don't push the filter all the way in when you start a load, socks can find their way there. Static electricity can cause socks stick to other clothes in the dryer.

How do I unblock my dryer? ›

How to Clean Out a Dryer Vent in 7 Simple Steps
  1. Gather Your Cleaning Supplies. ...
  2. Pull the Dryer Out From the Wall, Unplug It, and Disconnect the Duct. ...
  3. Vacuum the Inside of the Vent. ...
  4. Connect the Flexible Rods in Your Dryer Duct Cleaning Kit to Your Power Drill. ...
  5. Turn On the Drill and Let the Brush Work Its Magic.
Dec 8, 2021

Can coins damage dryer? ›

Coins, keys, and any other tiny pieces of metal.

Unfortunately, they both can damage your washer or dryer. They can harm the drum, and in rare cases even break the panel for front loaders.

What happens if metal goes in the dryer? ›

Can you put metal in the dryer? It's not recommended. Garments with metal decorations or rhinestones can melt, discolor, or break, ruining the clothing and potentially damaging other items or your dryer. Always hang dry these items or, if the material is especially delicate, lay them flat on a towel to air dry.

Can metal in a dryer cause a fire? ›

Also regularly sweep out dust in the areas around and underneath your dryer. Opt for a solid metal dryer duct. Research shows that flexible foil or plastic ducts can sag and lead to lint buildup at low points. Metal ducts of any variety don't sag, and they're more likely to contain any fires that would start.

Can metal damage a dryer? ›

Anything metal can scrape the inside of the metal drum and cause a spark inside the heating dryer. Anything that can make a mess or a fire is a hazard inside the dryer, and that comprises many things that go through the wash in pockets.

Can things bleed in the dryer? ›

When you put wet clothes in the dryer, the heat causes the fibers of the fabric to open up and release any dye that is still present in the fabric. So, if you have a white shirt that has been dyed pink, putting it in the dryer with a red shirt will cause the pink dye to bleed onto the red shirt, ruining both shirts.

Can you open a dryer door from the inside? ›

Many models of refrigerators, washers and dryers are made so that the door can be opened from either side.

What happens if you put something too heavy in the dryer? ›

Your load of laundry will take much longer to dry. When you pack in too many clothes, towels and sheets, your dryer has to work harder to get them dry. Trying to do its job, the motor of your expensive dryer can overheat and eventually burn out. It's also hard on the belt, pulley assembly and spindle bearings.

How do you remove something that fell in dryer lint trap? ›

In the lint trap alcove, you will need to remove the catch and unscrew two securing screws there as well. Once both the cover and the alcove screws have been removed, that back cover should come off. You will now be able to get a hand inside there and retrieve the item from inside that cover.

What type of metal is in a dryer? ›

Dryers have many different metals inside of them like insulated copper wires, electric motors, and steel.

How much scrap metal is in a dryer? ›

Your average washer weighs about 170 lbs. and dryers are around 124 lbs. If you do the math based on these figures, you'd get $8.50 for your washer and $6.20 for the dryer. On the other hand, if you were to disassemble them, you'd earn a few more dollars for the aluminum, brass, and copper (if any) as well.

How much does it cost to unclog a dryer vent? ›

Normal range: $101 - $176. The average cost of dryer vent cleaning is $138 . It can range between $101 and $176 , depending on where you live and where your dryer is placed in your home.

Where do dryers get clogged? ›

Lint Builds Up

Most of us know to clean out a dryer's lint tray after each use. But experts warn you should also keep an eye out for lint behind and under the washer and dryer. Excess lint behind the dryer is a sign of a clogged vent system and can be very dangerous.

What to do if a coin gets stuck in the washing machine? ›

If your washer has a coin trap, you will see a small, square panel near the floor on the front or side of the machine. Open the door and remove the trap by turning it counterclockwise and pulling. The contents of the trap may surprise you. Remove them.

What happens if a coin is stuck in washing machine? ›

Can Coins Damage A Washing Machine? Yes, they certainly can. Coppers, keys and other metal objects can damage the inner drum and outer tub of your washing machine. In fact, leaving coins in your pocket can cause a leaky washer as well as damaged clothes.

What happens if you leave a coin in the washing machine? ›

Those little pieces of metal might seem harmless, but they can cause some serious damage to your washing machine. “[Coins] can damage the fins on the drain pump if they make it past the filter,” says James Peters, Kenmore Laundry Product Manager.

Can I clean the inside of my dryer with rubbing alcohol? ›

Rubbing alcohol is often an effective way to remove ink from both the dryer's drum and the paddles, which are the mechanisms that move your laundry around. Gently wipe the affected areas of the dryer with a sponge that has been saturated with rubbing alcohol.

Can you clean inside of tumble dryer? ›

Clean around the drum area and in the crevices, using a stainless-steel cleaner. Remove the lint filter, brushing off accumulated fluff with your fingers. If your manufacturer recommends it, wash with warm water. Vacuum the lint filter area, using a narrow attachment to get at loose fluff, dust and hair.

Can you clean dryer drum with alcohol? ›

You can wipe down the drum with rubbing alcohol to ensure extra cleaning, but make sure to leave the door open for an hour before operating.

Why is my dryer door so hard to open? ›

Feel where the door resists, and gauge the point where it swings open or swings closed. Try loosening or removing the screws that hold the hinges tightly in place and test again. You may be able to repair the hinge by adjusting the screws for an evener balance. Or you may be able to bend the hinge back into place.

Can you open dryer early? ›

4. Let the cycle finish. Stopping a tumble dryer mid-cycle can stop the fans inside from working, allowing the dryer to reach dangerously high temperatures. If you do open your dryer before the cycle has completed, make sure all items can be quickly removed and the door is left wide open to let the heat escape.

What is the easiest dryer to repair? ›

Dryer Serviceability

If you are a do-it-yourself kind of person this should be a buying consideration. Whirlpool top lint trap dryers are extremely easy to open and repair, while LG, Samsung, and other high end Whirlpool, Maytag, and Frigidaire dryers may require a major time commitment to service or repair.

Is unplugging a dryer safe? ›

What if you just unplug the dryer? For the most part, you'll be safe to work on your dryer if it is unplugged. There are some components that have capacitors and similar parts that store power and can discharge while it's unplugged but for the most part you are safe when it's unplugged.

Is it OK to let dryer run overnight? ›

Smoldering lint inside the dryer or vent pipe evidently spread late at night. Never leave a dryer running when you're away from home, and never leave it running while you're sleeping.

Is it OK to run dryer empty? ›

Yes, run one cycle empty so the dryer can "burn" off and out gases from the materials, as these may get into the first load of clothes.

What is key lock on dryer? ›

Keylock. This option enables you to deactivate the buttons on the display panel, except for the 'POWER' and 'Keylock' buttons. This prevents accidental button presses.

What does LOC mean on dryer? ›

The Loc Error code indicates that the Control Lock has been enabled. When the control is locked, the dryer will not start or operate. Some models will look like the following: Press and hold the Control Lock Key for 3 seconds to unlock the machine.

Can you flip the door on a dryer? ›

You can absolutely switch the direction that your dryer door opens, reversing the dryer door, just by moving the hinges and the handle.

Should the dryer door be left open after use? ›

Unless you have an ongoing moisture problem inside your dryer, like from an onboard steam system, there isn't much of a reason you should have to leave it open.

Top Articles
Latest Posts
Article information

Author: Nathanial Hackett

Last Updated:

Views: 6446

Rating: 4.1 / 5 (72 voted)

Reviews: 87% of readers found this page helpful

Author information

Name: Nathanial Hackett

Birthday: 1997-10-09

Address: Apt. 935 264 Abshire Canyon, South Nerissachester, NM 01800

Phone: +9752624861224

Job: Forward Technology Assistant

Hobby: Listening to music, Shopping, Vacation, Baton twirling, Flower arranging, Blacksmithing, Do it yourself

Introduction: My name is Nathanial Hackett, I am a lovely, curious, smiling, lively, thoughtful, courageous, lively person who loves writing and wants to share my knowledge and understanding with you.